Volume 18, Issue 2 (June 2021)
Abstract
(15680 Views) |
Full-Text (PDF)
(5739 Downloads)
|
Graphical Abstract
|
Highlights
- The introduction of a gas via a bubble stream into a melt is a novel and safe method for the study of the early stages of surface film formation without the complicating issue of exposed melt contamination in furnaces. The technique would need some improvements to be reliable at very low oxygen partial pressures.
- Characterization of the initial surface films on molten AZ91D and AM60B alloys were investigated in non-isothermally state under reactive (dry air, SF6 and HFC-134a) and non-reactive (UPH Argon) atmospheres by SEM and EDS techniques.
- Effect of Al element as a reactive surface element on oxidation and fluoridation behavior of the molten Mg alloy was studied.
- A comparatively study has been done in this research so that a rough and folded surface film morphology in Mg-Al alloy is compared to thin and fine wrinkled oxide film under dry air in molten pure Mg alloy.
Abstract
(23307 Views) |
Full-Text (PDF)
(7311 Downloads)
|
Graphical Abstract
|
Highlights
- The type of heat treatment has a significant effect on the hot flow behavior of AA6061 and AA6063 aluminum alloys.
- The heat treatment effects on the flow behavior of AA6061 are more than AA6063 alloy.
- The heat treatment effects on the thermomechanical behavior of both alloys decrease with increasing temperature.
- The type of heat treatment has a lesser effect with increasing deformation temperature.
- The work hardening rates are higher for aged aluminum alloys compared to annealed ones.
- The volume fraction of precipitations decreases with increasing deformation temperature.
Abstract
(22690 Views) |
Full-Text (PDF)
(5562 Downloads)
Abstract
(19149 Views) |
Full-Text (PDF)
(5844 Downloads)
Abstract
(21583 Views) |
Full-Text (PDF)
(10814 Downloads)
Abstract
(20394 Views) |
Full-Text (PDF)
(5705 Downloads)
Abstract
(19098 Views) |
Full-Text (PDF)
(6832 Downloads)
Abstract
(23884 Views) |
Full-Text (PDF)
(5879 Downloads)
|
Graphical Abstract
|
Highlights
- The low velocity impact (LVI) response of pure and GFRPs containing various loading of SWCNTs was investigated using the drop-weight impact machine
- The absorbed energy of incorporated GFRP with different weight percent of SWCNT was studied.
- LS-DYNA numerical explicit finite element code was used to simulate the impact process of neat and incorporated GFRP with functionalized SWCNT.
- Experimental and numerical LVI test results were compared in the terms of maximum contact force and back-face damage area of specimens.
Abstract
(22030 Views) |
Full-Text (PDF)
(6029 Downloads)
Abstract
(15257 Views) |
Full-Text (PDF)
(11190 Downloads)
Abstract
(27116 Views) |
Full-Text (PDF)
(6092 Downloads)
Abstract
(21099 Views) |
Full-Text (PDF)
(6212 Downloads)
Export as:
HTML
|
XML
|
RSS